Justin's Toyota Service

Install Oil Cooler Inlet Tube No

• RepairSurge Auto Repair Software
• Best Plans To Build HHO Dry Cell with HHO Torch

(a) Temporarily install the oil cooler outlet tube No.1.

(b) Temporarily install the oil cooler inlet tube No.1.

C83206

(c) Install the oil cooler tube clamp with the bolt. Torque: 5.4 N m (55 kgf cm, 48 in. Ibf)

HINT:

Install them so that the oil cooler tube cushion is positioned as shown in the illustration.

(d) Torque the oil cooler inlet tube No.1. Torque: 34 N m (350 kgf cm, 25 ft Ibf)

Front

Front

C83206

Cable Bracket No.1

G34934

27. INSTALL OIL COOLER OUTLET TUBE NO.1

(a) Torque the oil cooler outlet tube No.1. Torque: 34 N m (350 kgf cm, 25 ft Ibf)

28. CONNECT CONNECTOR

(a) Connect the transmission wire connector.

(b) Connect the park/neutral position switch connector.

(c) Connect the 2 speed sensor connectors.

(d) Connect the speedometer driven gear connector.

29. INSTALL STARTER ASSY

(a) Install the starter assy with the 2 bolts. Torque: 37 N m (377 kgf cm, 27 ft Ibf)

(b) Connect the connecter.

(c) Connect the starter wire with the nut. Torque: 9.8 N m (100 kgf cm, 87 in. Ibf)

30. CONNECT WIRE HARNESS

(a) Connect the wire harness with the bolt. Torque: 13 N m (130 kgf cm, 9 ft Ibf)

31. INSTALL WIRE HARNESS CLAMP

(a) Install the 2 clamps with the 2 bolts. Torque: 8.4 N m (86 kgf cm, 74 in. Ibf)

(b) Connect the wire harnesses to the clamps.

32. INSTALL TRANSMISSION CONTROL CABLE BRACKET NO.2

(a) Install the transmission control cable bracket No.2 with the bolt.

33. INSTALL FRONT DRIVE SHAFT ASSY LH (SEE PAGE 30-8)

34. INSTALL FRONT DRIVE SHAFT ASSY RH (SEE PAGE 30-8)

35. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE (SEE PAGE 14-29)

36. RESET MEMORY NOTICE:

Perform the RESET MEMORY (AT initialization) when replacing the automatic transmission assy, engine assy or ECM (see page 05-1123).

HINT:

RESET MEMORY can not be completed by only disconnecting the battery terminal.

0 0