Justin's Toyota Service

Www.system Cable Spedometer Corolla

• Best Plans To Build HHO Dry Cell with HHO Torch
• RepairSurge Auto Repair Software
• Easy Small Engine Repair Guide

COMPONENTS

Defroster Nozzle Garnish

Register

Front Pillar Garnish

Register

Finish Lower Panel Assembly

Speaker Panel

Combination Meter

Check Arm

Instrument Cluster Finish Panel

Under Cover

Cowl Side Trim Board

Glove Compartment Door

Finish Lower Panel

Heater Control Panel

Heater Control Unit

Radio and Stereo

Console Upper Panel

Under Cover

Console Assembly eoo9n

REMOVAL OF SAFETY PAD

1. DISCONNECT CABLE FROM NEGATIVE TERMINAL OF BATTERY

2. REMOVE STEERING WHEEL

3. REMOVE STEERING COLUMN COVER

4. REMOVE CONSOLE ASSEMBLY

(b) Remove the ash tray.

(c) Remove the five heater control knobs.

(d) Remove the three screws and heater control panel.

(e) Remove the six set screws, disconnect two connectors, and remove the console upper panel.

(f) Remove the eight screws, disconnect the connectors, and remove the console assembly.

5. REMOVE HOOD RELEASE LEVER BRACKET

6. REMOVE DRIVER SIDE SPEAKER PANEL

Pry loose the panel with a screwdriver and remove it.

7. REMOVE DRIVER SIDE UNDER COVER

Remove the three screws, two clamps and cover.

8. REMOVE DRIVER SIDE FINISH LOWER PANEL

Remove the six screws, disconnect the four connectors, and remove the lower panel.

9. REMOVE INSTRUMENT CLUSTER FINISH PANEL

Remove the five screws, and disconnect the connectors. Then remove the cluster finish panel.

10. REMOVE COMBINATION METER

(a) Remove the four screws.

(b) Disconnect the connectors and speedometer cable.

(c) Remove the combination meter.

11. REMOVE PASSENGER SIDE COWL SIDE TRIM BOARD

(a) Remove the scuff plate screw.

(b) Remove the four screws and cowl side trim board.

12. REMOVE PASSENGER SIDE INSTRUMENT PANEL UNDER COVER

Remove the three screws and the under cover,

13. REMOVE PASSENGER SIDE SPEAKER PANEL

14. REMOVE PASSENGER SIDE FINISH LOWER PANEL ASSEMBLY

(a) Remove the glove compartment door check arm and the compartment door.

(b) Remove the door lock striker.

(c) Remove the finish lower panel.

(d) Disconnect the two connectors. NOTE: If necessary, remove the speaker.

15. REMOVE ECU

(a) Disconnect the three connectors.

(b) Remove the three screws and the ECU.

16. REMOVE SCREWS OF HEATER CONTROL ASSEMBLY

Remove the four screws of the heater control assembly. NOTE: Do not disconnect the heater control cable.

17. REMOVE FRONT PILLAR GARNISH

Pry loose the clips with a screwdriver, and pull the garnish upward to remove it.

18. REMOVE DEFROSTER NOZZLE GARNISH

Using a screwdriver, pry between the defroster nozzle garnish and safety pad.

CAUTION: Be careful not to scratch the safety pad.

19. REMOVE SAFETY PAD

(a) Remove the seven screws and one bolt.

(b) Disconnect the four connectors.

(c) Remove the safety pad.

(d) Remove the left and right side defroster nozzle ducts.

(e) Remove the instrument panel center register from the safety pad.

(f) Remove the left and right instrument panel side registers from the safety pad.

(g) Remove the side defroster retainer and defroster nozzle.

INSTALLATION OF SAFETY PAD

INSTALL PARTS OF SAFETY PAD IN REVERSE SEQUENCE OF REMOVAL

+1 0

Average user rating: 5 stars out of 1 votes