Adjust Drive Pinion Preload
Using a torque meter, measure the preload of the backlash between the drive pinion and ring gear.
Preload:
New bearing
19 - 26 kg-cm (16.5-22.6 in.-lb, 1.9-2.5 N-m) Reused bearing
9-13 kg-cm (7.8-11.3 in.-lb, 0.9-1.3 N-m) If preload is greater than the specification, replace the bearing spacer.
(b) If preload is less than specification, retighten the nut 130 kg-cm (9 ft-lb, 13 N-m) at a time until the specified preload is reached. If the maximum torque is exceeded while retlghtenlng the nut, replace the bearing spacer and repeat the preload procedure. Do not back off the pinion nut to reduce the preload.
Maximum torque:
Related posts
- Sst 09514-35011 Toyota Land Cruiser FJ BJ HJ 62 70 73 75 Repair
- Disassemble Wheel Cylinder Toyota Land Cruiser FJ BJ HJ 62 70 73 75 Repair
- Assemble Synchronizer Ring Holder Toyota Land Cruiser FJ BJ HJ 62 70 73 75 Repair
- Sst Mkd Toyota Land Cruiser FJ BJ HJ 62 70 73 75 Repair
-
Adjust Steering Knuckle Alignment Toyota Land Cruiser FJ BJ HJ 62 70 73 75 Repair
Post a comment