Remove Components Of First And Reverse Brake Piston
(a) Set SST on the spring retainer, and compress the return spring.
SST 09350-30020 (09350-07050)
(b) Remove the snap ring with snap ring pliers.
(c) Remove the piston return spring.
(d) Hold No. 2 first and reverse brake piston with hand, apply compressed air to transmission case to remove No. 2 first and reverse brake piston.
(e) Remove No. 2 first and reverse brake piston.
If the piston does not pop out with compressed air, lift the piston out with needle-nose pliers.
(f) Remove the O-ring from No. 2 piston.
(g) Insert SST behind the reaction sleeve and gradually lift it out of the transmission case.
SST 09350-30020 (09350 07080)
(h) Remove the O-ring from the reaction sleeve.
(i) Insert SST behind No. 1 brake piston and gradually lift it out of the transmission case.
SST 09350-30020 (09350-07090)
(j) Remove the two O-rings from No. 1 piston.
40. REMOVE MANUAL VALVE LEVER, SHAFT AND OIL SEALS
(a) Using a chisel, cut off the spacer and remove it from the shaft.
(b) Using a pin punch, drive out the pin.
(c) Pull the manual valve lever shaft out through the case and remove the lever.
(d) Using a screwdriver, remove the two oil seals.
Post a comment